Paradyne Hotwire 8300 User Manual page 86

2. Web Server Interface
You can configure or change the above-listed parameters on the Static TCP
Translation Details screen
appropriate number under the Index column on the Static TCP Translation Table
screen.
Figure 2-58. NAT Static TCP Translation Details Screen
Static UDP Translation Table Screen
The Static UDP Translation Table screen
global UDP Server ports to a local host IP Address/port combination. The
parameters described below enable access to UDP Servers on the
private/corporate network behind the NAT. The parameters may be used only
when in NAPT mode.
Figure 2-59. Static UDP Translation Table Screen
Global Port Decimal IP Port exposed to the global Internet. Default is 0.
Server Port Decimal IP Port of the local UDP Server. This port is usually the same as the
Global Port. Default is 0.
Server Address IP Address of the local UDP Server. Default is 0.0.0.0.
The Static UDP Translation Table screen provides the following user-activated
buttons:
2-68
Button Function
NAT Details Returns the user to the previous screen.
Add New Lets the user add an additional address.
April 2003
(Figure 2-58), which is accessed by selecting the
(Figure 2-59) allows static mapping of
8300-A2-GB20-00