Table of Contents
Advertisement
2. Web Server Interface
Web Server Access
You can access the Web Server interface by connecting to its IP address. This
connection can be directly through the 10/100 Ethernet port, in-band via PPP over
any port, or in-band via encapsulated IP traffic on the ATM WAN circuit.
NOTICE:
To access the Web Server interface, type the unit's IP address in the browser's
Address (or Location) field and press the Enter key.
Layout of Interface Screens
When you first access the Web Server interface, your browser will display a
screen that is divided into three frames. The upper frame forms a border across
the top of the screen; it identifies the unit in service and displays the hardware and
software revision and serial numbers under which the unit is operating. The far
right corner of the upper frame displays whether or not a Save and Restart is
necessary when parameters are changed on the currently displayed screen.
The area beneath the upper frame is divided into two side-by-side frames. The
frame on the left side of this area depicts a hierarchical tree structure used to
navigate through the various interface screens. Each branch on the tree guides
you to more specific upper-level information about the unit and its configuration.
Note that the Interfaces, Applications, and Utilities branches do not link to a page;
these branches simply provide structure for navigation. The frame on the right side
of the screen displays the actual configuration screen. The screen images
throughout this chapter show only the configuration portion of the screen, except
in the case of the Unit screen, which shows the left and right frames. The Unit
screen represents the top of the navigation tree.
2-2
Any changes to the unit's configuration MUST be followed by a
Submit if there is a Submit button on the menu. If you change the
Service Table, you must perform a Save and Restart.
April 2003
8300-A2-GB20-00
Advertisement
Table of Contents
