Table of Contents
Advertisement
2. Web Server Interface
Figure 2-43. Circuit Details Screen
Endpoint
Endpoint name. By default, the first circuit is always the LAN circuit. WAN circuit
endpoint names are taken from the VPI/VCI number. For example, VPI 0/VCI 32
will have P0-C32 for an endpoint name. The pull-down menu will display a list of
VPI/VCIs actually configured. A given circuit will receive/transmit data on the
VPI/VCI combination corresponding to its endpoint name.
IP Address
IP Address of the circuit.
IP Mask
IP Mask of the circuit.
Max Transmit Unit
Maximum transmit unit this circuit will send at any one time.
Cost
Represents the relative time of treatment of an IP packet. This value is used when
there are multiple routes to the same destination. When two or more routes are
available, the one with the lowest circuit cost is selected. An ATM circuit should
have a higher value than a LAN circuit.
RIP Status
Indicates whether or not RIP is enabled on this circuit.
Multicast Status
Indicates whether or not Multicast is enabled on this circuit.
2-52
Values:Disable, Listen and Talk, Talk Only, Listen Only
Default:Listen and Talk
Values: Enable, Disable
Default: Enable
April 2003
8300-A2-GB20-00
Advertisement
Table of Contents
