Table of Contents
Advertisement
3. VT100 Interface
Figure 3-25. Supervisory Screen
Speed
Used to change the Supervisory port speed (in bits per second).
Character Size
Selects the number of bits required to make up one asynchronous character.
Parity
Sets the parity bit.
Stop Bit
Selects the number of bits required to end the character.
DTR Alarm Control
Lets you set DTR Alarm Control parameters. Selecting Enable allows the unit to
go into alarm on loss of DTR, which occurs when the Supervisory port detects that
the DTR signal is low.
DTR Alarm Status
Lets you view the current DTR Alarm status.
Diagnostic
Enables the Supervisory port to send out diagnostic messages upon power-up.
Messages
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory interface screen.
3-28
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Values: Five, Six, Seven, Eight
Default: Eight
Values: None, Odd, Even
Default: None
Values: 1, 2
Default: 1
Values: Enable, Disable
Default: Disable
Values: Enable, Disable
Default: Enable
April 2003
8300-A2-GB20-00
Advertisement
Table of Contents
