Table of Contents
Advertisement
Wire Pair
Always Wire Pair 1.
Selecting the Maintenance prompt from the Span Endpoint Details screen will
display the screen shown in
operations (e.g., loopbacks) to be performed on segment endpoints.
Figure 3-14. Span Endpoint Maintenance Screen
The Span Endpoint Maintenance parameters are described below.
Loopback Type
Specifies loopbacks for the associated segment endpoint.
Loopback Timeout
Specifies the timeout value in minutes for loopbacks initiated at this endpoint. A
value of 0 disables the timeout.
Tip Ring
Indicates the state of the tip/ring pair at the associated segment endpoint.
Power Source
Indicates the DC power source being used by the associated unit.
Restart Endpoint
Enables the manager to trigger a soft restart of the SHDSL line at the associated
segment endpoint. Set this object to restart to initiate a restart. A restart will occur
after approximately 5 seconds.
Selecting the Performance prompt on the Span Endpoint Details screen will
display the screen shown in
8300-A2-GB20-00
Values: No Loopback, Normal Loopback
Default: No Loopback
Values: Ready, Restart
Default: Ready
April 2003
Figure
3-14. This table supports maintenance
Figure
3-15.
3. VT100 Interface
3-15
Advertisement
Table of Contents
