Table of Contents
Advertisement
2. Web Server Interface
Rule Details Screen
Access the Rule Details screen
Aware parameters, by selecting the appropriate hyperlink from the Index column in
the above screen. To establish a rule, select the desired rule configuration options,
provide the appropriate filter information where required, and click on the Submit
button at the bottom of the screen.
Figure 2-35. Rule Details Screen
The paragraphs below describe the rule configuration parameters and their
options.
Service
Selects the service to which the rule applies. Select from a pull-down menu that
lists available services.
VPI
Selects the VPI to which the rule applies.
VCI
Selects the VCI to which the rule applies.
Filter By VPI/VCI
Enables or disables filtering of the IP traffic in accordance with the specified
VPI/VCI.
NOTICE:
IP Address
Establishes the IP Address by which the rule will filter IP traffic (if enabled).
IP Mask
Represents a range of IP Addresses defined so that only machines with IP
Addresses within the range defined by the mask are allowed to access an Internet
service. To mask a portion of the IP Address, replace it with the wild card character
0 (zero). (For example, 192.44.0.0 represents every computer on the Internet with
an IP Address beginning with 192.44.)
2-44
(Figure
To use this filter, you must specify both the Service and VPI/VCI
parameters in the Rule Config screen.
April 2003
2-35), where you can establish Service
8300-A2-GB20-00
Advertisement
Table of Contents
