Table of Contents
Advertisement
Figure 3-43. Circuit Details Screen
Endpoint
Endpoint name. By default, the first circuit is always the LAN circuit. All
other circuits are associated with Endpoint names as defined in the Endpoint
Table.
IP Address
IP Address of the circuit.
IP Mask
IP mask of the circuit.
Max Transmit Unit
Maximum transmit unit this circuit will send at any one time.
Cost
Represents the relative time of treatment of an IP packet. This value is used when
there are multiple routes to the same destination. When two or more routes are
available, the one with the lowest circuit cost is selected. A frame relay circuit
should have a higher value than a LAN circuit.
RIP Status
Indicates whether or not RIP is enabled on this circuit.
Multicast Status
Indicates whether or not Multicast is enabled on this circuit.
OSPF Status
Indicates whether or not OSPF is enabled on this circuit.
8300-A2-GB20-00
Values:Disable, Listen and Talk, Talk Only, Listen Only
Default:Listen and Talk
Values: Enable, Disable
Default: Enable
Values: Enable, Disable
Default: Enable
April 2003
3. VT100 Interface
3-51
Advertisement
Table of Contents
