Table of Contents
Advertisement
3. VT100 Interface
VCI
Selects the VCI to which the rule applies.
Filter By VPI/VCI
Enables or disables filtering of the IP traffic in accordance with the specified
VPI/VCI.
NOTICE:
IP Address
Establishes the IP Address by which the rule will filter IP traffic (if enabled).
IP Mask
Represents a range of IP Addresses defined so that only machines with IP
Addresses within the range defined by the mask are allowed to access an Internet
service. To mask a portion of the IP Address, replace it with the wild card character
0 (zero). (For example, 192.44.0.0 represents every computer on the Internet with
an IP Address beginning with 192.44.)
Filter By IP Address
Enables or disables filtering of the IP traffic by the IP Address specified in the IP
Address or IP Mask field.
Enter IP Port or
Establishes the IP port by which the rule will filter IP traffic (if enabled).
Select From List
Filter By IP Port
Enables or disables filtering of the IP traffic by the IP port specified in the IP Port
field.
Tx Alarm Threshold
Specifies the threshold in bits per second for the Transmit Alarm on this rule.
Tx Alarm
Displays the current Transmit Alarm status.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen displays the number of frames and octets sent
over a VPI/VCI that have been counted in accordance with the Service Aware rule
that has been established for a Service. As such, it is ATM specific (i.e., VPIs/VCIs
only occur in ATM links). In addition, this screen provides data rate performance
information for the period of time specified in the <Period> field (see below).
3-46
To use this filter, you must specify both the Service and DLCI
parameters in the rule configuration.
April 2003
8300-A2-GB20-00
Advertisement
Table of Contents
