Table of Contents
Advertisement
1. About the Hotwire 8300 Endpoint
Rear Panel Connections
The rear panel of the 8300 Endpoint has five connectors. From left to right, these
are as follows:
and
Figure 1-2.
Power Port
The
connector. To apply power to the unit, simply plug the supplied power cord into the
unit's
outlet. The unit has no power switch.
When power is applied to any 8300 Endpoint, the front panel indicators flash for
approximately 10 to 15 seconds as the unit initializes. The green
the front panel will remain illuminated as long as the unit receives power. This LED
turns amber when the unit is in test mode.
CAUTION:
NOTICE:
Power Failure
If the indicator does not illuminate, check the power connections and the primary
circuit breaker.
The 8300 Endpoints provide nonvolatile memory retention of the unit configuration
in case of a power failure. The unit will automatically restore normal service
following a power loss and will retain pre-existing time and date information.
1-8
P O W E R
S U P E R V I S O R Y P O R T
,
as shown in Figure 1-2. below.
N E T W O R K
8300 Endpoint Rear Panel
port on the 8300 Endpoint is a standard, grounded, three-prong
P O W E R
port and then connect the wall plug to an appropriate electrical
P O W E R
Always connect the power cord to a grounded electrical outlet.
Per UL 1950 and CSA 60950 Clause 1.7.2, if the power supply
cord is intended to serve as a disconnect device, an easily
accessible socket must be installed near the equipment.
April 2003
1 0 / 1 0 0 E T H E R N E T
S E R I A L
,
,
P O W E R
8300-A2-GB20-00
C B R
,
,
LED on
Advertisement
Table of Contents
