Table of Contents
Advertisement
PSD Type
Sets the use of symmetric or asymmetric Power Spectral Density (PSD) mask.
NOTICE:
Line Probe
Enables or disables rate adaptation line probe.
To change any configuration profile parameter, enter the desired value/information
in a field or select the desired parameter from one of the pull-down lists, and then
press the Esc key.
Alarm Profiles Screen
Selecting the Alarm Profiles prompt on the 8300 Endpoint's Network Config
screen will display the screen shown in
Figure 3-10. Alarm Profiles Screen
The Alarm Profiles screen displays the current values of SHDSL alarm thresholds.
Information is displayed for the following alarm parameters:
Alarm Profiles
Name associated with this Alarm profile.
Loop Atten
Loop attenuation threshold.
SNR Margin
Signal-to-Noise Ratio margin threshold.
ES
Errored Seconds threshold.
8300-A2-GB20-00
Values: Symmetric, Asymmetric
Default: Symmetric
The 83000 Endpoint supports only symmetric PSD.
Values: Enabled, Disabled
Default: Enabled
April 2003
Figure
3-10.
3. VT100 Interface
3-11
Advertisement
Table of Contents
