Dimensional Data; Installation Space; Installation Procedure - Hitachi PC-ARF Technical Catalogue

4 Individual remote controls
PC-ART

4.2.2.4 Dimensional data

4.2.2.5 Installation space

If several control units are to be installed in a vertical position, leave a distance of at least 50
mm between them to allow the front cover to be opened and to insert the tool for removing
the control from its housing.

4.2.2.6 Installation procedure

1 Using a flat-head screwdriver, separate the control unit bracket from the front section as indicated.
Bracket
Groove
Screwdriver
2 Place the control unit in the housing, as indicated below (2 examples):

In cases where the remote control cable is exposed.
a. Secure the bracket to the wall using the 2 screws provided.
119
TCGB0106 rev.0 - 12/2014
120
HIGH Mon Tue Wed Thu Fri Sat Sun
FAN SET 1234S SET TEMP.
MED
NEXT SCHEDULE
˚C
COOL ON
ON
LOW
%
OFF
HEAT
ADDS RNHR
NO FUNCTION
DRY
OPER.LOCK AUTO CONTROL
UNIT
DEFROST SERVICE ABNML FILTER
AUTO
A/C
CENTRAL
T.RUN CHECK RCSTHM
VENTI H.STRG
RUN/STOP TEMP
Groove
Screwdriver
(mm)
15
20
Bracket
Indent part
Fix the holding bracket
with the mark "↑UP"
upward
Screw
(Accessory)
4
At least
50 mm
Bracket