Hitachi PC-ARF Technical Catalogue page 720

8 Control support devices
PSC-A1T
Press the "SET/MONITOR" button.
"SET" mode is switched off and setting mode switches to monitor mode.
N O T E
• In the case where the ON TIME or OFF TIME comes during the setting mode, there is no operation or stoppage. After setting, ensure
to change the mode of the control timer to the monitor mode. (For more than 3 minutes without setting operation at the setting mode,
the mode of the control timer is automatically changed to the monitor mode.)
• During the timer pause mode, the mode is not changed to the setting mode by depressing the "SET/ MONITOR" switch.

Time settings for: ON/OFF
N O T E
• In case that the centralised ON/OFF controller (PSC-A16RS) is used together, both setting of ON TIME and OFF TIME are required
for setting 1, 2 and 3. (The setting of ON TIME (or OFF TIME) only is not available).
• In case that the other controller is used together, the setting of ON TIME (or OFF TIME) only is available.
• During the timer pause mode, the mode is not changed to the setting mode by depressing the "SET/MONITOR" switch.
<Example> "A" pattern, Friday, Setting 2, PM 1:00 (ON) / PM 5:00 (OFF)
Press the "SET/MONITOR" button.
The remote control timer switches to setting mode, the "SET" indication will appear and the ▼ symbol
will flash.
The diagram on the right shows an example of the switch to setting mode.
Select schedule mode A or B by pressing "A/B".
Refer to the previous point "Changing weekly schedule mode (A or B)" for changing the pattern.
The diagram on the right shows the case of selecting the set pattern "A".
Select the day of the week on which to set the "ON/OFF" control
When "DAY" is pressed, the flashing symbol ▼ will move in the following sequence:
"Sun > Moon > ... > Sat"
By pressing "DAY" after "Sat", all ▼ symbols will flash (from Sun to Sat). In this case, the setting is the
same for all days of the week. By pressing the "DAY" button once more, the flashing symbol ▼ will
return to "Sun".
The diagram on the right shows the case of selecting the day "Friday". The flashing "▼" mark of the
present day is turned ON. (In case of selecting the present day, the "▼" mark flashes.)
Press the "ON/OFF TIME" button.
The timer will switch to "ON/OFF" time setting mode and the "ON TIME" indication will flash.
The diagram on the right shows the switch to "ON/OFF" time setting mode.
Select setting 1, 2 or 3 by pressing "SELECT".
When "SELECT" is pressed, the time indication will flash.
The diagram on the right shows the selection of setting 2.
Set the "ON TIME" hour by pressing the "HOUR/MINUTE" button  or .
After setting the time indication, press "OK"; the "ON TIME" minute indication will flash.
The diagram on the right shows the time set to 1 PM:--
Set the "ON TIME" minutes by pressing "HOUR/MINUTE"  or .
After setting the minute indication, press "OK"; the "OFF TIME" time indication will flash.
The diagram on the right shows the time set to 1:00 PM.
704
TCGB0106 rev.0 - 12/2014
Turned OFF
Turned ON
Turned ON
Turned ON