Hitachi PC-ARF Technical Catalogue page 339

5 Centralised remote controls
PSC-A32MN
Swing louvre direction
1 Select the target group for the change of swing louvre direction at the "Monitor 1 (All Groups)" or "Monitor 2 (Block)"
screens. The screen with the settings for the selected group is displayed on the touchscreen.
Monitor 1 (All Groups)
(1)
2 By tapping " " or " " of the "LOUVRE", the swing louvre direction changes alternatively as shown below.
: Auto swing operation is started.
AUTO
3 Tap "Monitor screen" to return to the "Monitor" screen.
(3)
N O T E
• When there are two or more groups registered in the same block, it is possible to change the target group for setting by tapping the
arrow buttons at the upper corners of the screen.
• In case that control mode is set as "Run/Stop Only", setting changes affect all groups or all blocks.
It is not possible to change settings for each group.
• Depending on the type of air conditioner, the setting may not be possible or may be calibrated automatically.
• The louvre position displayed on the LCD and the actual louvre position do not always match during the auto swing operation.
• The actual swing louvre direction may not stop immediately after the switch is pressed.
323
TCGB0106 rev.0 - 12/2014
LCD
indication
AUTO
COOL
Angle range
DRY
HEAT Angle range
FAN
Monitor 2 (Block)
(1)
(2)
5