Hitachi PC-ARF Technical Catalogue page 219

4 Individual remote controls
Receiver kit for wireless remote control
5 Attach the receiver kit to the lower cover.
a. Insert the receiver kit and the connecting cable to the position for receiver kit.
b. Lead the connecting cable through the hole for connecting cable.
c. Catch 3 hooks of receiver kit onto the square hole. Pay attention to the direction of receiver kit when it is attached.
Receiver Kit
N O T E
Check whether the receiver kit is securely fixed.
6 Lead the connecting cable into the electrical box with other wires.Attach the accessory insulation to the edge of side
cover R in order to prevent a scratch by contacting the connecting cable to the edge of side cover R.
Lower Cover
7 Remove the electrical box cover. Connect the connecting cable to the terminals A and B at the terminal board for re-
mote control switch as following figure. (There are no polarity between terminals A and B.)
Printed Circuit Board (PCB1)
203
TCGB0106 rev.0 - 12/2014
Attaching DIrection for
Receiver Kit
Side Cover R
Lower Cover
Terminal Board for Remote
Electrical Box
Control Switch
Mark Band A
Service Hole
Hole for Connecting
Hook
Receiver Kit
Side Cover R
Insulation
Put the side cover R and the flange at
lower cover between insulations.
Connecting Cable for Receiver Kit
Connecting Cable for R
Mark Band B
Cable
4
Hook