Hitachi PC-ARF Technical Catalogue page 561

6 Building air conditioning controls
CSNET Manager LT/XT

Operation panel
Operation panel is the interface available in table of indoor units and building layout view, that is shown by default and it is
used to send orders to the units. In case of using a virtual remote controller, the panel is hidden.
The Operation Panel has the following access fields offering complete control of the units:
• Setting
• System Status
Each of these fields is explained below.
N O T E
Visibility of these fields depends on privilege level of the user.
Setting
This option shows the parameters which can be selected for each indoor unit.
After selecting the parameters to be adjusted, press
(Cancel) to cancel the operation.
1 Select the unit. The unit selected in the table of indoor units is identified by the Location field. Using the Set by field,
select the group of units whose parameters you want to adjust:
Name
Indoor unit
Outdoor unit
Area
Zone
Zone and
subzones
CS Port
All
Selection
2 Adjust parameters. Click with the mouse on the parameter you want to select. Select the temperature with the buttons
"" or ">". The temperature margin is:
- From 19ºC to 30ºC for cooling.
- From 17ºC to 30ºC for heating.
Select the fan speed and the position of the baffle plate by pushing the Fan speed and Louver buttons.
N O T E
Automatic mode cannot be set for units with the RAC adapter PSC-6RAD so that the option will not appear on screen when this type of
units is selected.
3 Parameter lock. The parameters selected in RCS Lock will remain locked in the previous position when the option was
activated. This means that they cannot be modified from the remote control.
N O T E
ON/Off lock only locks in OFF. Unit always can be stopped from the remote control.
545 545
TCGB0106 rev.0 - 12/2014
The selected indoor unit
All the indoor units belonging to the same outdoor unit than the selected one.
All the indoor units belonging to the same tree area unit than the selected one.
All the indoor units on the same building layout zone than the selected unit.
All the indoor units on the same building layout zone and zones below the same zone where the
selected unit belong.
All the units connected to the device on the same CS Port than the selected units
All the units
The selected units on the table or layout.
(Update) to send the order to the units selected or
Send the order to
6