7 Gateways for building management systems
KNX001
7.3 KNX001
7.3.1 Safety summary
C A U T I O N
•
This interface KNX001 must be installed by skilled personal (electrician, EIB installer or other skilled technician).
•
Do not connect voltage input to the control system before installation has been correctly completed.
•
This appliance must be used only by adult and capable people, having received the technical information or instructions to handle
properly and safely this appliance.
•
Children should be supervised to ensure that they do not play with the appliance.
•
Install KNX001 away from possible sources of electromagnetic waves.
•
Respect local electrical standards.
•
Use a power circuit that is not subject to peak demands.
•
Ensure that there is enough free space around the KNX001 so that the heat may dissipate adequately
(refer to "Installation Work").
•
If you install the KNX001 in vertical position, install the power supply in the lower part and the temperature control outputs in the
upper part.
Do not install KNX001 in places... :
•
outdoor.
•
with vapour, oil or dispersed liquids.
•
exposed to sun radiation.
•
with heat sources nearby (sulphuric surroundings).
•
where accumulation, generation or leaks of inflammable gases has been detected.
•
that are near the sea, in saline, acid or alkaline surroundings.
•
with wet environment.
N O T E :
•
Read this manual carefully before performing installation and configuration works.
•
For additional information concerning programming and software operation, please refer to the CSNET WEB information.
646
646
TCGB0106 rev.0 - 12/2014