4 Individual remote controls
PC-ARF
Individual Louver Setting
Setting
This setting is available only for the indoor unit adopting the individual louver. Each louver angle can be set individually.
N O T E
•
This function is available only when the indoor unit corresponds to the individual louver.
•
This function cannot be set when the unit is stopped.
•
The fan speed changes to "LOW" while this function is being set. (After the setting is completed, the unit operation returns to normal).
•
As for "Start-up of Heating Operation", "During Defrost Operation" and "Activation of Thermo-Controller", all the louver angles are fixed
at horizontal position automatically even when this function is activated.
•
This function is not available if 2 remote control switches (including multifunctional remote control switch + wireless remote control
switch) are used.
•
With one multifunctional remote control switch, a maximum number of 4 indoor units can be set for this function.
1 Select "Louver Setting" from the menu and press "OK".
The individual louver setting menu is displayed then.
2 Select "Louver Setting" from the individual louver setting menu
and press "OK".
N O T E
If the number of indoor units connected with the remote control is 1, the
screen passes directly to display the step 4 after this step.
3 Select the indoor unit to change the louver direction by press-
ing " ", " ", " " or " ". Press "OK".
N O T E
The indoor unit displayed on the screen flashes if the individual louver is
set.
4 Press " " or " " and select the louver from 1 to 4. The se-
lected louver is opened and the other louvers are closed.
5 Select the louver angle by pressing " " or " " and press "OK".
The confirmation screen will be displayed.
The louver angle will be changed as follows.
INDV
INDV
INDV
N O T E
The louver direction without "INDV" complies with the setting of the normal
mode.
98
TCGB0106 rev.0 - 12/2014
INDV
INDV
INDV
INDV
OK
OK
Louver Setting
Louver Setting
Cancel INDV Louver SET
SEL.
Louver Setting
01-01
01-02
01-03
01-04
Select unit to set.
SEL.
Louver Setting:01-03
1
Adjust air direction & louver angle
SEL.
Louver Setting:01-03
1
Adjust air direction & louver angle
INDV
SEL.
Menu
15:10(Fri)
Louver Setting
Louver Open/Close
02
VENTI
/
Total Heat Exchanger SET
03
Motion Sensor Setting
SEL.
ENT.
RTN.
OK
OK
ENT.
RTN.
OK
ENT.
RTN.
2
3
4
ADJ
ENT.
RTN.
OK
2
3
4
ADJ
OK
ENT.
RTN.