Hitachi PC-ARF Technical Catalogue page 206

Hide thumbs Also See for PC-ARF:

Table of Contents

4 Individual remote controls

Receiver kit for wireless remote control

5 Draw the connection cable through the wiring hole

on the indoor unit and pass it over the unit's sus-

pension bracket to the receiver kit installation po-

sition. Secure any excess cable with a cable tie.

6 Install the air panel accessory on the indoor unit.

7 Connect the receiver kit using the following procedure.

a. Route the connection cable

outside the box and connect it

to the receiver kit cable. Once

connected, cover the connec-

tor with the wiring cover and

secure the cables using a

flexible cable tie.

a. Hook the cable tie onto the air panel ring at the back of the re-

ceiver kit, as shown in the following diagram.

a. Hook the L-shaped tab on the back of the receiver kit into the

square hole of the air panel.

8 Hook the other fixing tabs (3 positions) into the square holes of the air panel.

When removing the receiver kit after installing the air panel:

The corner point of the receiver kit can be raised by inserting a coin or flat-head

screwdriver in the area marked  and pressing downwards. With  raised, turn

a coin or flat-head screwdriver under positions  and , and the entire receiver

kit will lift up.

After disconnecting the fixing tabs (3 positions), slide the receiver kit in the direc-

tion of the arrow  and remove it.

TCGB0106 rev.0 - 12/2014

Connection cable

Wiring hole of the

Corner division

Connection cable

Receiver kit

Suspension bracket

Coin or flat-head screw-

Troubleshooting