Hitachi PC-ARF Technical Catalogue page 221

Hide thumbs Also See for PC-ARF:

Table of Contents

4 Individual remote controls

Receiver kit for wireless remote control

Installation procedure

C A U T I O N

Follow these installation procedures carefully. Failure to do so may cause the receiver to become detached from the panel causing a

serious accident.

1 Install the wireless receiver kit and indoor unit at the same time.

2 If installing the wireless receiver kit after the indoor unit, unplug the power source from the indoor unit.

3 Make sure the distance between the wireless receiver kit and indoor unit is less than 5 metres.

4 Remove the cover using a flat-head screwdriver.

5 Install the wireless receiver kit on the wall or ceiling, as shown below:

In cases where the remote control cable is exposed

a. Mount the wireless receiver kit fixing bracket with the screws (A) at

the 4 positions.

b. Cut one of the pre-drilled holes (*) on the cover.

c. Run the cable through the groove and pull it out through the pre-

drilled hole.

d. Fit the cover, making sure not to snag the cable.

TCGB0106 rev.0 - 12/2014

Fixing bracket

Troubleshooting