Hitachi PC-ARF Technical Catalogue page 195

4 Individual remote controls
PC-LH3(A/B)
Air flow direction
Point the transmitter towards the receiver kit and press "LOUVER" switch to set the louver angle.
By pressing "LOUVER" switch, the louver angle will be changed as follows.
: Auto swing operation will be started. At this time, the louver will swing repeatedly on LCD.
N O T E
• The louver angle is not displayed during the stoppage.
• The louver setting are only available from 1 step through 5 step and auto swing at the cooling and dry operation modes.
• The louver angle may be changed automatically during the heating operation. (Refer to the installation and operation manual of indoor
unit about detail.)
• The louver may NOT stop immediately right after the switch is pressed.
• The auto louver mechanism is not available for In-the-Ceiling type.
179
TCGB0106 rev.0 - 12/2014
Hi
°C
The louver angle is set
to 1 step at "Hi" in the
COOL
cooling operation.
Step
LCD indication COOL, DRY HEAT, FAN
-
Recommended
1
angle
2
Angle
3
range
4
5
6
7
Auto-swing
Angle
range
Recommended
angle
4