Hitachi PC-ARF Technical Catalogue page 178

4 Individual remote controls
PC-ARH
3 Choose one of the following installation options for securing the remote control, depending on the installation re-
quirements:
- With remote control cable exposed.
- Using an electrical box.
- With a bedside table.

In cases where the remote control cable is exposed.
Secure the cable holder accessory to the wall using 2 M4 screws (ac-
cessories).

If using an electric control box.
There are different types of electrical boxes available on the market
that can be used for this installation, for example:
- Electrical box for one control unit (with or without cover.)
- Electrical box for 2 control units (with or without cover.)
- Other types of box
1 Pass the cable through the wall duct.
2 Pass the cable through the electrical box.
3 To secure the bracket to the box, make sure you leave the neces-
sary length of cable, taking into account the height of the terminals
A and B.

If using a bedside table
1 Cut a hole to leave the remote control exposed and prepare the bolts
(over 140 mm), as shown in the diagram.
N O T E
The bolts must be positioned in-line with the spacers (field supply).
2 Fit the bolts into the fixing bracket and secure the spacers with nuts.
- Bolt (field supply).
- Nut (field supply).
- Spacer (field supply).
N O T E
Leave a distance of at least 30 mm between the spacer holes.
162
TCGB0106 rev.0 - 12/2014
Box
Screws M4 (field supply)
Bold
Bold(field supply)
Nut (field supply)
Spacer (field supply)
or more