Prc-(10-30)E1; Components List; System Description; Installation Procedure - Hitachi PC-ARF Technical Catalogue

9 Control accessories

PRC-(10-30)E1

9.3 PRC-(10-30)E1

9.3.1 Components list

Unpack the unit and check that:
• The package contains all the components (see next table).
• All components are in perfect condition.
Otherwise, contact the manufacturer.
Name
PCC-1A connector cord
Installation manual

9.3.2 System description

The PRC-(10/15/20/30)E1 is a 2P extension cable intended for individual remote controllers or central extensions whose
cables need to be extended up to more than 30 m. When the total cable length is not higher than 30 m, other type cable
(more than 0.3 mm ) can be used.
2
For the details of the optional 2P extension cable, refer to the table:
Model Length (m)
PRC-10E1 10
PRC-15E1 15
PRC-20E1 20
PRC-30E1 30

9.3.3 Installation procedure

If the remote control cable requirement is longer than 30 m, connect a control cable (2 x 0.75mm2) in the field, by soldering,
or use an optional extension remote control cable.
• The remote control cable can be extended to a maximum of 500 m.
• Extend the Remote Control Cable as shown in the figure
N O T E
Cut, connect each wire by twisting, and then solder it. Insulate each wire with a vinyl tape.
Remote
Control
753
TCGB0106 rev.0 - 12/2014
Figure Quantity
1
1
Specification
Ø 3.6 Beige colour
Indoor unit
(2 Twisted wires)
PCB side
50
Cut
Optional Remote Control Cable (PRC-(10-30)E1)
Comments
For extending the length of individual and
central remote controllers
Installation unit instructions.
Remote control
switch side
100
9