Hitachi PC-ARF Technical Catalogue page 102

4 Individual remote controls
PC-ARF
3 Select the indoor unit by pressing "
*This screen is not displayed when the number of indoor units con-
nected with the remote control switch is 1 (one). In this case, go
directly to the step 4..
4 To start initialization, select "Yes" and press "OK" on the con-
firmation screen. It takes approx. 30 seconds to complete the
process.
*Check that initialization does not cause any problems, and then
start the initialization work.
5 Select "Completed" and press "OK". The test run menu is dis-
played then.
Press " " (return) on the test run menu to return to the normal mode.
To initialize setting for the other indoor units, select "I.U. Select" and
press "OK". The screen returns to step 3.
N O T E
• "No Function" is indicated when the indoor unit that does not support the initialization function for "Function Selection" and "Input/
Output Setting".
• The setting for indoor units that does not support the initialization function for "Function Selection" and "Input/Output Setting" is not
initialized even when "All" is specified at step 3.

Compressor Preheating Cancellation
This function cancels the compressor preheating control.
1 Press and hold " " (menu) and " " (return) simultaneously for at
least 3 seconds during the normal mode (when unit is not oper-
ated). The test run menu is displayed then.
2 Select "COMP Preheating CANC" from the test run menu press-
ing " " and "OK", then the confirmation screen is displayed.
3 Select "Yes" and press "OK". The test run menu is displayed after
the setting is confirmed. If "No" is pressed, the screen returns to
test run menu.
4 Press " " (return) on the test run menu to return to the normal mode.
86
TCGB0106 rev.0 - 12/2014
" and press "OK".
FUNC, Input/Output INITIAL.
02-04
FUNC, Input/Output INITIAL.: 02-04
COMP Preheating CANC
Contact Information
COMP. Preheating Control CANC
Cancel preheating control
for compressor?