Hitachi PC-ARF Technical Catalogue page 136

Hide thumbs Also See for PC-ARF:

Table of Contents

4 Individual remote controls

b. Insert the cable through the hole in the control unit. A hole can be made in the top centre and top left hand side..

c. Strip the cable insulation and connect to terminals A and B.

If using an electric control box.

There are different types of electrical boxes available on the market that can be used for this installation, for example:

Electrical box for one control unit (with or without cover.)

Electrical box for 2 control units (with or without cover.)

Other types of box

1 Pass the cable through the wall duct.

2 Pass the cable through the electrical box.

3 To secure the bracket to the box, make sure you leave the necessary length of

cable, taking into account the height of terminals A and B.

C A U T I O N

Make sure the cable is not loose and that the length is correct. If it is left loose, it may be-

come pinched when the control unit is fitted to the bracket, possibly causing an operational

4 Strip the cable insulation and connect to terminals A and B.

5 Control unit assembly procedure

Insert the hooks on the control unit into the holes on top of the

Push the bottom part of the unit towards the bracket.

A click sound indicates that the control unit is secured to the brack-

et and the assembly procedure is complete.

TCGB0106 rev.0 - 12/2014

Connect terminals

Troubleshooting