Hitachi PC-ARF Technical Catalogue page 337

Hide thumbs Also See for PC-ARF:

Table of Contents

5 Centralised remote controls

Main parameters settings

Operation Mode

1 Select the target group for the change of operation mode settings at the "Monitor 1 (All Groups)" or "Monitor 2 (Block)"

screens. The screen with the settings for the selected group is displayed on the touchscreen.

Monitor 1 (All Groups)

2 By tapping the " " or " " buttons under "Operat. Mode", operation mode changes alternatively as shown below:

The "AUTO" (Heating/Cooling Automatic Operation) is also included as an option when applicable.

3 Tap "Monitor screen" to return to the Monitor screen.

When there are two or more groups registered in the same block, it is possible to change the target group for setting by tapping the

arrow buttons at the upper corners of the screen.

In case that control mode is set as "Run/Stop Only", setting changes affect all groups or all blocks.

It is not possible to change settings for each group.

Some modes cannot be set, depending on the type of air conditioner unit. Contact your dealer or a Hitachi customer service centre

for detailed information.

TCGB0106 rev.0 - 12/2014

Monitor 2 (Block)

Troubleshooting