Hitachi PC-ARF Technical Catalogue page 225

4 Individual remote controls
Receiver kit for wireless remote control
d. Fit the cover, making sure not to snag the cable.

If using an electric control box.
a. There are various types of electrical boxes on the market which
can be used for this installation, for example:
- Electrical box for one remote control unit (without cover.)
- Electrical box for one remote control unit (with cover)
- Output box (with cover)
Also used:
- Rigid metal duct (at least Ø20)
- Screws (M4) (field supply)
b. Insert the cable into the rigid metal duct.
c. Mount the wireless receiver kit fixing bracket using the screws
supplied by the installer. The diagram shows a switch box for 1
remote control.
d. Fit the cover, making sure not to snag the cable.
6 Remove the cover from the electrical box of the indoor unit and con-
nect the cable to terminals A and B on the terminal plate.
N O T E
If using the RPK model, connect the cable to the CN13 connector (3P blue) on the
PCB of the indoor unit using the cable with connector (factory-supplied with the
RPK).
After connecting the cable, tie any excess cable using a cable tie (factory-sup-
plied) and insert in the electrical control box.
209
TCGB0106 rev.0 - 12/2014
Hook
Cover
Click sound
Fixing bracket
Cable
Cable
The screws sup-
plied by the in-
staller
Hook
Cover
Click sound
Fixing bracket
4