Hitachi PC-ARF Technical Catalogue page 106

4 Individual remote controls
PC-ARF
Setting the louver direction
1 Press " " (run/stop). Make sure that the operation is start-
ed. Press " " or " " and select "LOUV".
N O T E
For the indoor unit without the auto louver mechanism, the indication of
"LOUV." will NOT be displayed on LCD.
2 By pressing " " or " ", the louver direction will be changed
as follows.
: Auto swing operation will be started. At this time, the lou-
ver will swing repeatedly on LCD.
N O T E
• The air flow angle is different for each indoor unit type. Check
Installation & Operation Manual for Indoor Unit to be used for the
detailed information.
• Louver position on LCD and the actual louver position may not
match during the auto swing operation. To fix the louver positions,
set the angle after checking the position on LCD.
• The louver may NOT stop immediately right after the switch is
pressed.
90
TCGB0106 rev.0 - 12/2014
Meeting Room
A/C
MODE SPEED
COOL
MED
OK
SPEED
LCD Indication COOL, DRY HEAT, FAN
Auto-swing
Recommended
angle
Angle range
Angle range
Meeting Room
A/C
MODE SPEED
COOL
MED
OK
SPEED
LOUV. TEMP
TEMP ADJ
Recommended
angle
LOUV. TEMP
TEMP ADJ