Table of Contents
Advertisement
Chapter 3. Internal cable routing
See this section to do cable routing for specific components.
Note: Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from
the system board. Failing to release them before removing the cables will damage the cable sockets on the
system board, which are fragile. Any damage to the cable sockets might require replacing the system board.
Cable routing for 2.5-inch drives
Follow the instructions in this section to learn how to do cable routing for 2.5-inch drives.
Go through the following list to acquire necessary information before starting cable routing for 2.5-inch
drives.
Preliminary parts removal and installation
1. Make sure the following components are removed beforehand:
• Top cover (see
"Remove the top cover" on page
• Both 4U PCIe riser cages (see
• Chassis air baffle (see
• 4U PCIe expansion tray (see
• Processor and memory expansion tray (see
page
219)
• Fan cage (see
"Remove the fan cage assembly" on page
2. Make sure to install all the drive backplanes that you plan to installed (see
carrier assembly" on page
© Copyright Lenovo 2020, 2022
"Remove a 4U PCIe riser cage" on page
"Remove the chassis air baffle" on page
"Remove the 4U PCIe expansion tray" on page
"Remove the processor and memory expansion tray" on
144).
240)
255)
270)
153)
"Install a drive backplane
249)
47
Advertisement
Table of Contents
