Figure 83. Internal CFF adapter installation
Step 3.
Connect cables to the adapter. See
After you finish
Complete the parts replacement. See
Intrusion switch replacement
Use this information to remove and install the intrusion switch. The intrusion switch informs you that the
server cover is not properly installed or closed by creating an event in the system event log (SEL).
•
"Remove the intrusion switch" on page 123
•
"Install the intrusion switch" on page 124
Remove the intrusion switch
Use this information to remove the intrusion switch.
About this task
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
BmyijyY0-lNvapM4fTV5Gf
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 56
73.
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5
Hardware replacement procedures
271.
269.
to ensure that you
123