Intrusion Switch With Cable Replacement - Lenovo ThinkEdge SE350 V2 Hardware Maintenance Manual

• Connect the cable to the front operator assembly (see
page 134).
• Proceed to complete the parts replacement (see
Demo video
https://www.youtube.com/watch?v=kI13TgI3PI8

Intrusion switch with cable replacement

Follow instructions in this section to remove or install an intrusion switch with cable.
Remove the keylock switch with cable
Follow instructions in this section to remove the intrusion switch with cable.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read "Installation Guidelines" on page 1
you work safely.
• Remove the shipping bracket, if applicable (see
server and disconnect the power cords (see
• Remove the node from the enclosure , if applicable (see
lay the node on a flat, static-protective surface.
Procedure
Step 1. Make preparations for this task.
a. If applicable, unlock or remove any locking device that secures the top cover, such as a
Kensington lock; then, remove the top cover (see
b. Remove the air baffle (see
Step 2. Remove the intrusion switch with cable from the node
a. Remove the screw that secures the intrusion switch to the sidewall of the node.
ThinkEdge SE350 V2 Hardware Maintenance Guide
60
"Cable routing for the front operator assembly" on
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 2
"Configuration guide" on page
"Power off the server" on page
"Configuration guide" on page
"Remove the top cover" on page
"Remove the air baffle" on page
125).
to make sure that
9); then, power off the
8).
9); then, carefully
32).
122).