Omron OMNUC FND Series User Manual page 9

The OMNUC FND-X-series Position Driver allows motor test operation only by wiring the driver
and motor without connecting the controller. Read 3-2 Turning ON Power and Checking Dis-
play , properly set the motor model code, and then operate the motor according to 3-8-2 System
Check Mode .
Do not connect any load (machines) when performing test operation. Perform test operation
only after confirming that no adverse effects will be caused by test operation.
SYSMAC C/CV
Programmable Controller
SYSMAC C200H-HX/HG/HE
or CQM1 Programmable
Controller
Initial Operation (Starting)
3-1 Operation Procedure
3-2Turning ON Power and Checking Displays
Function Settings (Parameter Settings)
3-4 Setting Functions: User Parameters (H Parameters)
3-5 Position Control Settings (PTP Parameters)
3-6 Setting Positioning Data (PTP Data, Direct Input)
Trial Operation and Adjustments
3-8-1 Trial Operation Procedure
3-8-2 System Check Mode
3-9-1 Auto-tuning
3-9-2 Manually Adjusting Gain
Troubleshooting
4-4 Protection and Diagnosis
4-5 Troubleshooting
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VISUAL INDEX
For users who wish to begin operations quickly.
SRM1-C01/-C02
Master Controller
5-3-1 General Control
Cable Specifications
I/O signals
Section 6 CompoBus/S Specifications
CompoBus/S signals