Omron OMNUC FND Series User Manual page 179

Operation
Output Signal Test Operating Procedure
Display example
j Output Signal Numbers, Symbols, and Names
Number
S00
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S11
S12
S13
S14
3-66
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Press the Mode Key to enter Monitor Mode.
Hold down the Increment Key, Decrement Key, and Data Key simultaneously for at
least five seconds to enter System Check Mode.
Press the Shift Key to bring up the output signal test display.
Press the Data Key and Shift Key to enable the output signal test. (The output
signals will all be turned OFF.)
Use the Increment Key and the Decrement Key to select the signal. In this
example the origin signal (ORGSTP) is selected.
Press the Data Key to turn ON the output signal. ("1" indicates "ON.")
Press the Data Key again to turn OFF the output signal. ("1" indicates "OFF.")
Press the Mode Key to return to the output signal test display.
Double-click the Mode Key to return to Monitor Mode.
Symbol
READY
S.COM
ORGSTP
T.COM
RUNON
INP
ALM
P.OUT0
P.OUT1
P.OUT2
P.OUT3
P.OUT4
P.OUT5
P.OUT6
BO
Key operation
READY
Origin search completed
Origin stop
Teaching completed
Motor running
Positioning completed
Alarm
Point output 0 / Position selection 1
Point output 1 / Position selection 2
Point output 2 / Position selection 3
Point output 3 / Position selection 4
Point output 4 / Speed selection
Point output 5
Point output 6
Brake output
Chapter 3
Name