Omron OMNUC FND Series User Manual page 129

Operation
No. Name
UP-
25 Monitor output
26 Motor rotation
direction
28 Brake ON
speed
29 Motor test
speed
30 External
regeneration
resistance
value
31 External
regeneration
resistance
capacity
j H Parameters (HP-33, HP-46)
No. Name
HP-
33 Load rate time
46 In-position timer
3-16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Min. unit Setting Factory
range setting
--- 000 to 010
011
--- 0, 1 0
0.1% 0.0 to 1.0
100.0
1 r/min 1 to 50
8,000
0.1 Ω
0.0 to 0.0
100.0
0.01 kW 0.00 to 0.00
327.67
Min. Setting Factory
unit range setting
1 s 1 to 60 30
3.2 ms 3.2 to 3.2
320.0
Explanation
Specifies monitor output function.
0
Positive voltage
0: Not reversed
1: Reversed
Speed/Current selection
0: Current
1: Speed
Specifies motor rotation direction.
0: Forward rotation
1: Reverse direction
Specifies r/min to turn OFF break
output in on-hold brake mode.
Specifies rate based on rated motor
r/min as 100%.
* The brake may be damaged if the
on-hold brake mode is selected
for motors rotating at high speed.
Specifies r/min for motors for test-
ing.
* When testing a motor, make sure
that the set value is less than the
rated motor r/min.
Specifies the regeneration
absorption resistance value (Ω)
* Only valid for FND-X50H- .
* When using an OMRON External
Regeneration Resistor, set to 30.0
(Ω).
Specifies the regeneration
absorption resistance capacity
(kW).
* Only valid for FND-X50H- .
Explanation
Specifies interval for effective load
factor calculation to value obtained
from machine cycle time multiplied
by an integer.
Specifies minimum positioning
completion ON time and minimum
ready signal OFF time.
Chapter 3
Re-power
required?
No
No
No
No
Yes
Yes
Re-power
required?
No
No