Omron OMNUC FND Series User Manual page 192

Operation
Wiring the Regeneration Resistor
As shown in the following diagram, connect the Regeneration Resistor between the P and J terminals at
the Position Driver's terminal block.
Note With the FND-X50H- , connect a Regeneration Resistor between P and JP1. In this case,
remove the short bar between JP1 and JP2.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2
2.0 mm
Regeneration
Resistor
Position Driver terminal block
Chapter 3
3-79