Omron OMNUC FND Series User Manual page 60

Design and Installation
Power Cable Connectors
Servomotor Servomotor
Standard U1K030 -
U1K530 -
U2K030 -
With Brakes U1K030 -B
U1K530 -B
U2K030 -B
Encoder Cable Connectors
Servomotor
All models
j Other Precautions
Do not apply commercial power directly to the Servomotor. The Servomotors run on synchronous
AC and use permanent magnets. Applying 3-phase power will burn out the motor coils.
Do not carry the Servomotor by its cable, otherwise the cable may become disconnected or the cable
clamp may become damaged.
The shafts are coated with anti-rust oil when shipped. Apply anti-rust oil or grease to the shaft if nec-
essary. When anti-rust oil or grease is applied, connections such as couplings to the load shaft may
slip causing dislocations. Therefore, pay careful attention to the connections after applying anti-rust
oil or grease.
Absolutely do not remove the encoder/resolver cover or take the motor apart. The magnet and the
encoder/resolver are aligned in the Servomotor. If they become misaligned, the motor will not oper-
ate.
2-36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Connector model
model
R88M-
Elbow connectors:
CE05-8A18-10SD-B-
BAS
Straight connectors:
CE05-6A18-10SD-B-
BSS
Elbow connectors:
JL04V-8A20-15SE-EB
Straight connectors:
JL04V-6A20-15SE-EB
Connector model
Elbow connectors:
JA08A-20-29S-J1-EB
Straight connectors:
JA06A-20-29S-J1-EB
Cable clamp model
Sheath exterior diam-
eter of 6.5 to 8.7 mm:
CE3057-10A-3 (D265)
Sheath exterior diam-
eter of 8.5 to 11 mm:
CE3057-10A-2 (D265)
Sheath exterior diam-
eter of 10.5 to
14.1 mm:
CE3057-10A-1 (D265)
Sheath exterior diam-
eter of 6.5 to 9.5:
JL04-2022CK (09)
Sheath exterior diam-
eter of 9.5 to 13:
JL04-2022CK (12)
Sheath exterior diam-
eter of 12.9 to 15.9:
JL04-2022CK (14)
Cable clamp model
Sheath exterior diameter
of 6.5 to 9.5 mm:
JL04-2022CKE (09)
Sheath exterior diameter
of 9.5 to 13 mm:
JL04-2022CKE (12)
Sheath exterior diameter
of 12.9 to 16 mm:
JL04-2022CKE (14)
Chapter 2
Manufacturer
Daiichi Electronic
Industries Co.,
Ltd.
Japan Aviation
Electronics Indus-
try, Ltd.
Manufacturer
Japan Aviation Electron-
ics Industry, Ltd.