Omron OMNUC FND Series User Manual page 65

Design and Installation
Using OMNUC U-series AC Servomotors: 1 to 2 kW
SYSMAC CV/C-series
Programmable Controller
Encoder Cable
R88A-CRUB N
(for incremental encoder/
absolute encoder)
Note 1. Refer to Chapter 5 Specifications for connector and cable specifications.
Note 2. To perform mounting in accordance with EC Directives, use a Servomotor that conforms to
EC Directives. In addition, replace the connectors for the power cable and the encoder cable
at the Servomotor with the recommended Connectors listed under Water and Drip Resist-
ance in 2-1-2 Installation Conditions.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
C200HX/HG/HE or CQM1
Programmable Controller
General-purpose
Control Cable
FND-CCX S
FND-X-series Position Driver
(DIO Type)
Power Cable
R88A-CAUB
R88A-CAUB
CompoBus/S Communications
Cable (SCA1-4F10 Flat Cable
or commercially available VCTF
cable)
FND-X-series Position Driver
(CompoBus/S Type)
N
Backup Battery
B
Connect when using a
Servomotor with an abso-
lute encoder.
OMNUC U-series AC
Servomotor: 1 to 2 kW
Chapter 2
SRM1-C01/-C02
Master Control Unit
2-41