Omron OMNUC FND Series User Manual page 127

Operation
User Parameters Display Example
Parameter number (UP-01) display
Data display (UP-01 contents)
Parameter number (UP-02) display
Data display (UP-02 contents)
Parameter number (UP-03) display
Data display (UP-03 contents)
j Setting H Parameters
Use the following procedure to set the H parameters.
1. Press the Mode Key to go to the Users Parameter Edit Mode (UP-01).
2. Press the Increment Key, Decrement Key, and Shift Key simultaneously to display H parameter
HP-33.
3. Use the Up and Decrement Keys to display the parameter number (HP-
4. Press the Increment Key to display the parameter data.
5. Press the Data Key and Shift Key simultaneously to enable a data change. The rightmost digit will
flash.
6. Use the Up and Decrement Keys to change the data. The flashing numeral can be changed. To
move to the next digit, press the Shift Key.
7. Press the Data Key to save the changed data in memory.
8. Double-click the Mode Key to go from H Parameter Edit to the Monitor Mode.
H Parameters Display Example
User parameter display
Parameter number (HP-33) display
Data display (HP-33 contents)
Parameter number (HP-46) display
Data display (HP-46 contents)
3-14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 3
Rightmost digit
flashes.
) desired.
Rightmost digit
flashes.