Omron OMNUC FND Series User Manual page 268

Specifications
Note 1. The brakes are the non-excitation type. (When excitation voltage is added, it is cleared.)
Note 2. The operation time measurement is the measured value with a surge killer installed.
Note 3. For Servomotors with brakes, increase the dimensions of the radiation shield by 50 mm each.
(For example: t15 x
Note 4. The allowable radial load indicates the value at the center of the shaft (i.e., 1/2 of the output
shaft length). (See the diagram below.)
Note 5. The allowable radial load and the allowable thrust load are the values determined by taking a
service life of 30,000 hours at normal usage as the standard (or 20,000 hours for the items in
parentheses).
Note 6. M-series 4,000 r/min 1,100 to 2,000 W Servomotors can be used only with Position Driver
software version 4.04 (April 1999) or later.
j Torque and Rotation Speed Characteristics (Standard Cable: 3 m;
200/100-VAC Input)
1,200 r/min
R88M-M20012
Short-term op-
eration area
(within 1 s)
Continuous
operation area
(r/min)
R88M-M1K112
Short-term op-
eration area
(within 1 s)
Continuous
operation area
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
250 becomes t15 x 300.)
Radial load
Output shaft center
R88M-M40012
Short-term op-
eration area
(within 1 s)
Continuous
operation area
R88M-M1K412
Short-term
operation area
(within 1 s)
Continuous
operation area
Thrust load
R88M-M70012
Short-term op-
eration area
(within 1 s)
(r/min)
R88M-M1K812
Chapter 5
Continuous
operation area
(r/min)
Short-term
operation area
(within 1 s)
Continuous
operation area
5-45