Omron OMNUC FND Series User Manual page 81

Design and Installation
Point outputs 0 to 3 become the data output for digit 10
1
output for digit 10 .
Example: When point No. 12 is selected.
Point output
j Position Selection 1 to 4 [UP-01 (Control Mode) = 13 or 14]
This is the request signal output for obtaining positioning data.
Refresh the data for positions 0 to 7 (P.IN 0 to 7) according to the data request signals.
The output ON time can be set by PP-26 (selection signal output time). Adjust this parameter when
inputting data from a source such as a Programmable Controller.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
0
, and point outputs 4 to 6 become the data
6 5 4 3 2 1
0 0 1 0 0 1
Chapter 2
0
0: OFF, 1: ON
0
2-57