Installing Remote Control - Kemppi Minarc T 223 ACDC Operating Manual

2.6 Installing remote control

Remote controls are optional. Connect the remote control to the Minarc T 223 ACDC power source or the Flexlite TX
welding torch. To enable remote operation, set the remote mode in the control panel (refer to "Minarc T 223 ACDC con-
trol panel" on page 28).
Minarc T 223 ACDC is compatible with the following Kemppi remote controls:
• R10 hand remote control
• FR41 foot pedal remote control
• TXR10 torch remote control
• TXR20 torch remote control.
For information on installing a torch remote control, refer to
Remote control R10/FR41
1. Connect the remote control cable to the power source.
© Kemppi
Kemppi Userdoc.
21
Minarc T 223 ACDC
Operating manual - EN
1922350 / 2413