Installation - Kemppi Minarc T 223 ACDC Operating Manual

2. INSTALLATION

Do not connect the equipment to the mains before the installation is complete.
Do not modify the welding equipment in any way, except for the changes and adjustments covered in the man-
ufacturer's instructions.
Place the machine on a horizontal, stable and clean ground. Protect the machine from rain and direct sunshine.
Check that there is enough space (> 15 cm) for cooling air circulation in the machine vicinity.
Before installation
• Make sure to acknowledge and follow the local and national requirements regarding installation and use of high
voltage units.
• Check the contents of the packages and make sure the parts are not damaged.
• Before you install the power source on site, see the requirements for the mains cable type and fuse rating.
Distribution network
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the
public low-voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in
those locations, due to conducted as well as radiated radio-frequency disturbances.
Minarc T 223 ACDC: This equipment complies with IEC 61000-3-12 and can be connected to public low-voltage sys-
tems.
© Kemppi
11
Minarc T 223 ACDC
Operating manual - EN
1922350 / 2413