Table of Contents
Advertisement
2.
INSTALLATION
2.1 Connecting to a FastMig welding machine
To connect the carriage system to the FastMig welding
equipment:
1.
Connect welding cable to welding gun connector.
2.
Connect control cable to remote control connection at
the wire feeder.
3.
Connect control cable to 7-pin connection at the
carriage unit.
4.
Connect remote control unit to 7-pin connector on the
carriage front panel.
With Kemppi mechanization welding gun, the control
cable is integrated into the gun cable. The trigger mode
must be set to 2T. With other welding guns, you need to
use a separate control cable. See the ordering codes at the
end of this document.
When using a manual welding gun, start and stop
the arc with the gun trigger and start the carriage motion
with the remote control as usual. The trigger mode must
be set to 4T. See FastMig operation manual for further
instructions.
When using a Supersnake:
1.
Use the mechanization model of Supersnake.
2.
Connect as usual to the wire feeder, and connect the
carriage with the welding gun to the Supersnake.
This model includes a bus coupler with which to
connect.
© Kemppi Oy 2021
2.2 Connecting to a non-FastMig welding
You need a transformer (1-phase, 230 VAC) to power the
carriage. In this setup, the start button and the adjustment
of welding voltage and wire feed speed are not accessible
through the remote control device.
Do the following to connect:
5
A5 MIG Orbital System
machine
1.
Connect welding gun to the wire feeder.
2.
Attach welding gun to the carriage gun holder.
3.
Connect transformer to the carriage.
4.
Start welding by pressing the gun trigger.
R01
Advertisement
Table of Contents
