Parameter Fields For A Video Codec - Polycom ReadiManagerLX100 Administrator's Manual

Parameter Fields for a Video Codec

© Polycom, Inc.
The table below shows the parameter fields for a Polycom Viewstation MP. For a more
general description of how to set up a video codec, see
Polycom ReadiManager LX100
Parameter Field
Equipment
Parameter
Information
Control Port
Default Service
Direct Service
H.320 Service (ISDN)
H.323 Service (IP)
HTML Default Page
HTML Interface Port
SNMP Community
Telnet Port
Multipoint
Capabilities
Chapter 5 - Setting Up and Working with Resources
on page 73.
Description
Parameter fields vary from one type of equipment to another.
The fields and descriptions here are an example, shown for a
Polycom ViewStation MP.
Device-specific setting. Blank for ViewStation MP.
The default service used to connect with this endpoint. If
multiple services are available—for example, if a Video Codec
can be accessed through either IP or ISDN, or if there is a
choice of a Direct Connect, then the user can change the
connection method when they schedule the resource. For
details about how the user does this, see
Connection is Made on page 170.
Lets you define a Direct Connect service for this endpoint.
Note:
If you are defining Direct Connect for a video codec, you
must already have the Direct Connect service defined in the
MCU equipment record, and the MCU must be configured for
Direct Connect.
Setting Up a Direct Connect Service
For details, see
page 76.
Lets you define the H.320 Service used by this endpoint. Use
this link to enter the ISDN number and specify dialing rules to
be used. For details, see
on page 81.
Lets you define the H.323 Service used by this endpoint and
specify the Alias For details, see
(IP)
on page 79.
Default page of the built-in web server for this codec. Not
required for a ViewStation.
HTTP port for this codec. Not required for a ViewStation.
SNMP Community Name. A community name is used to weakly
authenticate queries to agents of managed network devices.
Port at which this endpoint can be reached via Telnet. Not
required for a ViewStation.
If the endpoint is capable of making embedded multipoint calls
without a separate bridge, specify the maximum number of calls
that can be supported using IP, ISDN, or both. If these fields are
Network Aware Scheduler
all blank,
embedded multipoint capability, even if it exists.
If it is desirable to have all multipoint calls ONLY occur from
stand-alone bridges, then do not enter values into these fields.
Setting up a Video Codec in
Changing How the
Setting Up H.320 Services (ISDN)
Setting Up H.323 Services
will not attempt to use any
on
75