Parameter Fields For A Polycom Mgc 100 - Polycom ReadiManagerLX100 Administrator's Manual

Polycom ReadiManager LX100 Scheduling Administrator's Guide

Parameter Fields for a Polycom MGC 100

70
6. In the Equipment Parameter Information section of the form, define the Services
used by this MCU.
This may include Direct Services, Gateway Services, H.320 (ISDN) Services, and
H.323 (IP) Services. For more information, see
To see where in MGC Manager to find the information you need to define these
services, see Where Services are Set in MGC Manager
7. Complete the IVR-related fields, if appropriate: IVR Capable, IVR IP Alias, and
IVR Number.
8. Complete the Conference Limits fields: Maximum CP Conferences, Maximum
Total Conferences, Maximum Total Participants and Maximum Transcoding Ports.
9. Turn on Alert Management, if desired. (For details, see the discussion of the Alert
Management field in
10. Click Update to save details about the MCU.
The table below describes parameter settings for an MGC 100. For general
step-by-step set-up instructions, see
ReadiManager LX100 on page 69.
Parameter Field
Equipment
Parameter
Information
Direct Services
Gateway Services
H.320 Services
(ISDN)
H.323 Services (IP)
Fields in the Equipment Information Form
Setting up an MGC 100 in Polycom
Description
Parameter fields vary from one type of equipment to another.
The fields and descriptions here are an example, shown for a
Polycom MGC 100.
Click this link to define Direct Connect Services parameters.
Note: You must define Direct Connect for the MGC before you
can define it for a video codec that connect to this MGC.
The MGC must also be configured for Direct Connect.
Setting Up a Direct Connect Service
For details, see
page 76.
Click this link to define specific gateway service channels
defined in the MGC.
An H.320 service must also be defined, which is referenced in
the gateway service form.
For details, see Setting Up Gateway Services
Click this link to define specific ISDN dial-out capability and dial
rules. You can also select a Least Cost Routing table. For
details, see Setting Up H.320 Services (ISDN)
Click this link to define specific IP service information for each
H.323 card in the MGC. For details, see
Services (IP)
on page 79.
Setting Up an MCU In Polycom ReadiManager LX100
Setting Up Services on page 76.
on page 84.
on page 65.)
on page 78.
on page 81.
Setting Up H.323
on