Using People + Content - Polycom ReadiManagerLX100 Administrator's Manual

Using People + Content

© Polycom, Inc.
Higher speed is important when you want high quality video in a meeting. However,
because higher speed uses more bandwidth, scheduling a meeting with higher speed
may limit the number of conferences that can be reserved at one time.
This setting controls the ability for one of the endpoints to send data and video over the
same bandwidth, so that both people and content can be displayed. The two video
streams are handled differently by the receiving endpoint, and may be shown on
separate screens, or through Video Switching mode.
Note: The MGC requires that conferences with People + Content use a Speed of at least
192 K. If you set the Speed to 128, the conference will fail.
Select the type of People + Content capability you want the conference to use. If you
do not want to display both people and content in this conference, leave this setting as
"None."
A conference can have only one People + Content setting. What you select here
determines the setting to be used for all participants in the conference.
Endpoints in the conference that don't support the selected method will connect with
either video (if they connect via IP) or audio only (if they connect via ISDN).
The available settings include:
None
People+Content
People and Content VO
Visual Concert PC
Visual Concert FX
H320 Duo Video
None
Select "None" when dual-streams of data are not required.
People + Content
This Polycom proprietary technology works with most Polycom endpoints.
Chapter 8 - Scheduling and Managing Conferences
167