Oracle X8-2L Service Manual page 165

3. Using a Torx T15 screwdriver, tighten the right-side and left-side spring-mounted
screws to secure the disk backplane to the chassis [4].
Reconnect the cables to the disk backplane.
4.
a. Reconnect the auxiliary signal cable to the disk backplane [5].
b. Reconnect the temperature signal cable to the disk backplane [5].
c. Depending on your storage drive configuration, do one of the following:
Reconnect the three SAS cables to the disk backplane [6].
■
To ensure proper SAS cable connections, see the SAS cabling reference table in
3 in "Install SAS Storage Drive Cables" on page
Reconnect the twelve NVMe cables (not shown) to the disk backplane
■
[6]
To ensure proper NVMe cable connections, see the NVMe cabling reference table
in Step 3
"Verify NVMe Cable Connections" on page
d. Reconnect the power cable to the disk backplane [6].
5. Return the server to operation.
Install the fan tray.
a.
See "Install the Fan Tray" on page
b. Install the fan modules.
See "Install a Fan Module" on page
c. Install the air baffle.
See "Install the Air Baffle" on page
Install the server top cover.
d.
See "Install the Server Top Cover" on page
e. Install all storage drives into the storage drive cage.
See "Install a Storage Drive" on page
in "Install NVMe Cables" on page
90.
87.
115.
74.
192.
198, and perform the procedures in
200.
218.
Servicing the Disk Backplane (FRU)
Install the Disk Backplane
Step
165