Reconnect Power And Data Cables; Power On The Server - Oracle X8-2L Service Manual

Reconnect Power and Data Cables

To identify the location of cable connectors on the back of the server, refer to
■
Connector Locations" on page
Related Information
"Reconnect Power and Data Cables" on page 222
■
Reconnect Power and Data Cables
Reconnect the data cables to the back of the server, as appropriate.
1.
If the cable management arm (CMA) is in the way, extend the server approximately 13 cm (5
inches) out of the front of the rack.
2. Reconnect the power cables to the power supplies.
3. If necessary, reinstall the cables into the cable management arm and secure
them with Velcro straps.

Power on the server.

4.
See "Power On the Server" on page
Related Information
"Disconnect Cables From the Server" on page 61
■
"Reinstall the Server Into the Rack" on page 219
■
"Return the Server to the Normal Rack Position" on page 220
■
"Power On the Server" on page 222
■
Power On the Server
As soon as the power cords are connected, Standby power is applied. In Standby power mode:
The System OK LED on the server front panel blinks slowly.
■
The SP OK LED indicator is steady on.
■
The AC power supply LED indicator lights are steady on.
■
Depending on the firmware configuration, the system might boot. If it does not boot,
perform the following procedure.
222 Oracle Server X8-2L Service Manual • January 2021
41.
222.
"Back Panel