Remove An Nvme Storage Drive; Verify Removal Of An Nvme Storage Drive - Oracle X8-2L Service Manual

Where $slot is the slot number obtained in step
Verify that the OK to Remove indicator (LED) on the NVMe drive is lit.
4.

Remove an NVMe Storage Drive

Perform this procedure to physically remove an NVMe storage drive from the server.
1. Identify the location of the NVMe drive that you want to remove.
For storage drive locations, see
2. Verify that the OK to Remove indicator (LED) on the NVMe drive is lit.
On the NVMe drive you plan to remove, push the latch release button to open the
3.
drive latch.
See "Remove a Storage Drive" on page
4. Grasp the latch and pull the drive out of the drive slot.
5. Consider your next steps:
If you are replacing the drive, continue to
■
Drive" on page
If you are not replacing the drive, install a filler panel in the empty drive slot to maintain
■
proper airflow and perform administrative tasks to configure the server to operate without
the drive.
For information on how to install a storage drive filler panel, see
Panels" on page

Verify Removal of an NVMe Storage Drive

1. To check the NVMe drive enumeration to verify that NVMe drive has been
removed, type:
#
lspci -nnd :0a54
2. View the command output and verify that the entry for the slot number that was
disabled no longer appears.
This commands returns output similar to the following:
"Remove a Storage Drive" on page
72.
81, and then "Install an NVMe Storage Drive" on page
217.
Remove an NVMe Storage Drive
Step 2b above.
72.
"Verify Removal of an NVMe Storage
"Remove and Install Filler
Servicing Storage Drives (CRU)
82.
81