2.1
Safety Information
This section describes important safety information that you need to know prior to
removing or installing parts in the Sun Blade X6275 server module.
Caution – Never attempt to run the server module with the cover removed.
Hazardous voltage present.
Caution – Equipment damage possible. The server module cover must be in place
for proper air flow.
For your protection, observe the following safety precautions when setting up your
equipment:
Follow all Sun cautions, warnings, and instructions marked on the equipment and
■
described in Important Safety Information for Sun Hardware Systems.
Follow all cautions, warnings, and instructions marked on the equipment and
■
described in the Sun Blade X6275 Server Module Safety and Compliance Guide.
Ensure that the voltage and frequency of your power source match the voltage
■
and frequency inscribed on the equipment's electrical rating label.
Follow the electrostatic discharge safety practices. See this chapter.
■
2.2
Required Tools
The Sun Blade X6275 server module can be serviced with the following tools:
Antistatic wrist strap
■
Antistatic mat
■
No. 2 Phillips screwdriver (with adjustable torque; set for 8 in-lbs)
■
Non-conducting stylus or pencil (to power on server)
■
2-2
Sun Blade X6275 Server Module Service Manual • September 2013