Servicing The Internal M.2 Flash Ssds (Cru); Remove A Flash Riser Board - Oracle X8-2L Service Manual

Servicing the Internal M.2 Flash SSDs (CRU)

This section describes how to service M.2 flash solid-state drives (SSDs). M.2 flash SSDs
are customer-replaceable units (CRUs) that do not require you to power off the server. For
more information about CRUs, see
Replaceable Units" on page
These procedures require that you handle components that are sensitive to
Caution -
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in
Safety" on page
This section covers the following procedures:
"Remove a Flash Riser Board" on page 99
■
"Install a Flash Riser Board" on page 101
■
"Identify and Remove an M.2 Flash SSD" on page 103
■
"Install an M.2 Flash SSD" on page 105
■
Related Information
"Servicing Storage Drives (CRU)" on page 69
■

Remove a Flash Riser Board

The server can contain up to two hot-pluggable flash riser boards. Each flash riser board can
contain either one or two M.2 flash SSDs.
1. Prepare the server for service.
a. Extend the server into maintenance position.
See "Extend the Server to the Maintenance Position" on page
"Illustrated Parts Breakdown" on page 20
21.
52.
"Electrostatic Discharge
62.
Servicing the Internal M.2 Flash SSDs (CRU)
and "Customer-
99